Craftsman 107.16575 - User Manual

Questions and Answers

W
walkerlisaAug 15, 2025
What to do if my Craftsman 107.16575 does not run?
- J
  Joshua YoungAug 15, 2025
  If your Craftsman Air Compressor isn't running, there are several potential causes: * Loss of power or overheating: Ensure proper extension cord use. * No electrical power: Verify the compressor is plugged in and the power switch is ON. * Blown fuse: Replace the fuse at the power supply. * Tripped breaker: Reset the breaker at the power supply. * Thermal overload open: Unplug the compressor and wait for it to cool down. The motor will restart when cool. * Bad pressure switch: Replace the pressure switch. * Tank is full: The compressor will turn on when tank pressure drops to the cut-in pressure.
D
Diane JamesAug 18, 2025
Why Craftsman Air Compressor air receiver pressure drops?
- F
  Frank MarshallAug 18, 2025
  If the air receiver pressure drops when your Craftsman Air Compressor shuts off, it could be due to: 1. Loose or leaking connections (fittings, tubing, etc.): Check all connections with soapy water for bubbles and tighten any loose connections until the leak stops. 2. Loose drain valve: Tighten the drain valve. 3. Leaking check valve: You will need to take the compressor to a service center.
A
Amanda PhillipsAug 21, 2025
What to do if Craftsman 107.16575 motor hums, but does not run?
- J
  Janet LawrenceAug 21, 2025
  If your Craftsman Air Compressor motor hums but doesn't run or runs slowly, it could be due to: * Low voltage from the power supply: Check the voltage with a voltmeter. * Wrong gauge wire or extension cord length: Use the correct wire gauge and length extension cord. * Shorted or broken motor winding: Take the compressor to a service center. * Defective unloader or check valve: Take the compressor to a service center.
K
Kimberly ClarkAug 25, 2025
How to fix excessive moisture in Craftsman Air Compressor discharge?
- G
  Gina MendozaAug 26, 2025
  To address excessive moisture in the air discharge of your Craftsman Air Compressor: * Excessive water in the air tank: Drain the tank to remove water. * High humidity: Move the compressor to an area of less humidity or use an air line filter to reduce moisture discharge in the tank.
V
Victor BullockAug 28, 2025
Why does the thermal overload protector cut out repeatedly on my Craftsman 107.16575?
- J
  Jamie MartinAug 28, 2025
  The thermal overload protector on your Craftsman Air Compressor may cut out repeatedly because of: * Low voltage from the power supply: Check the voltage with a voltmeter. * Poorly ventilated room: Move the compressor to a well-ventilated area to prevent the motor from overheating. * Incorrect gauge wire or extension cord length: Check for proper gauge wire and cord length.
E
ehuntSep 1, 2025
Why does my Craftsman Air Compressor run continuously?
- W
  wkhanSep 1, 2025
  Your Craftsman Air Compressor might be running continuously due to: * An open tank drain valve: Ensure the tank drain valve is closed. * A defective pressure switch: You will need to take the compressor to a service center. * Excessive usage: Decrease tool run-time because the compressor may not be large enough to supply the air requirement of the tool.
K
Katherine HarveySep 4, 2025
What to do if my Craftsman 107.16575 Air Compressor fuses blow repeatedly?
- H
  hnguyenSep 4, 2025
  If the fuses blow or the circuit breaker trips repeatedly on your Craftsman Air Compressor, consider the following: * Incorrect fuse size or overloaded circuit: Check that the fuse or breaker at the power supply is the correct size and type. Use only time-delay fuses. To avoid overloading a circuit, disconnect other electrical appliances or operate the compressor on its own branch circuit. * Wrong gauge wire or extension cord length: Use the correct wire gauge and length extension cord. * Defective unloader or check valve: Take the compressor to a service center.
T
Tracy WaltonSep 7, 2025
How to stop air leaking from my Craftsman 107.16575 Air Compressor?
- M
  Megan KingSep 7, 2025
  To stop air from leaking from your Craftsman Air Compressor: * Loose or improperly sealed hose connection: Ensure connections are sealed with thread sealing tape and tightened. * Broken or damaged air hose: Replace the air hose.
M
Megan JonesSep 12, 2025
How to fix a vibrating Craftsman 107.16575 Air Compressor?
- J
  Jesus BrownSep 12, 2025
  If your Craftsman Air Compressor is vibrating, it is likely that the compressor mounting bolts are loose. Tighten the mounting bolts.