Craftsman 113.243401 User Manual

1'Se'arsl
i i i iii
owners
manual
MODEL NO.
113.243401
SAW ON LY
MODEL NO.
113.243411
SAW WITH LEGS
AND MOTOR
Serial
Number
Mode{ and serial
number may be found
at the right-hand side
of the frame.
You should record both
model and serial number
in a safe place for
future use.
CAUTION:
Read GENERAL and
ADDITIONAL SAFETY
INSTRUCTIONS
carefully
12-INCH BANDSAW/
SANDER
• assembly
• operating
• repair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, IL. 60684 U.S.A.
PartNo. 69098 PrintedIn U.S.A.

Craftsman 113.243401 Specifications

General

Model Number	113.243401
Type	Table Saw
Blade Diameter	10 inches
Arbor Size	5/8 inches
Voltage	120 V
Max Cut Depth at 90°	3 inches
No Load Speed	5000 RPM
Rip Capacity	24 inches

Summary

General Safety Instructions

Safe Work Area and Personal Protection

Maintain a clean area, keep children away, wear proper apparel, and use safety goggles.

Safe Operation and Maintenance

Accident Prevention and Checks

Avoid accidental starts, use correct accessories, check parts, never stand on tool, and ensure proper feed.

Additional Safety Instructions

Operator Protection and Material Handling

Wear protective gear, handle materials safely, and avoid blade binding.

Location and Safety Awareness

Position saw correctly and maintain constant safety awareness during operation.

Operational Safety Warnings

Pulley Speed and Familiarity Hazards

Eye Protection and Instruction Plate

Emphasizes wearing safety goggles and following machine plate instructions.

Key Operational Safety Points

Critical reminders on blade installation, guide adjustments, and finger safety.

Motor Specifications and Electrical Requirements

Motor Specifications and Connection

Extension Cord Usage and Rotation Check

Installing the Band Saw Blade

Blade Guide and Thrust Bearing Adjustment

Blade Tracking Adjustment

Final Blade Guide and Bearing Setup

Table Adjustment and Switch Operation

Getting to Know Your Band Saw/Sander

Tension Adjustment and Scales

Table Tilting and Guide Adjustments

Thrust Bearing and Guide Bar Setup

Adjusting thrust bearings and aligning the guide bar for optimal performance.

Installing the Sanding Attachment

Guide Bar Alignment

Attachment Preparation and Mounting

Basic Band Saw/Sander Operation

Sawing Techniques

Sanding Operation Guide

Maintenance Procedures

Tire Care and Replacement

Troubleshooting Common Issues