What to do if my Craftsman Saw motor does not start?
If your Craftsman Saw motor doesn't start: * Replace the limit switch, as it may have failed. * Replace the brushes if they are worn. * Verify there is electrical power at the outlet, as the fuse may be blown or the circuit breaker tripped on the home panel.
What to do if the Craftsman Saw laser guide fails to turn on?
If the laser guide on your Craftsman Saw fails to turn on: * Replace the batteries, as they may be dead (use new AAA batteries). * Reload the batteries and make certain that they make solid contact to the battery spring, as the battery contacts may need adjustment.
Why does my Craftsman 137.21236 blade bind, jam, or burn wood?
Your Craftsman Saw blade may bind, jam, or burn wood due to several reasons: * Improper operation. * A dull or warped blade - replace or sharpen the blade. * Using an improper blade size - replace with a 10-inch diameter blade. * The wood is moving during the cut - use a hold-down clamp to secure the workpiece to the table.
Why does my Craftsman 137.21236 vibrate or shake?
Your Craftsman Saw might vibrate or shake because: * The saw blade is not round, damaged, or loose - replace the blade. * The arbor bolt is loose - tighten the arbor bolt.
What to do if the brake does not stop the Craftsman 137.21236 Saw blade within 6 seconds?
If the brake isn't stopping the Craftsman Saw blade within 6 seconds: * Inspect, clean, or replace the brushes if they are not sealed or lightly sticking. * Use a recommended blade and let the motor cool down if the motor brake overheated from using a defective or wrong-size blade or rapid ON/OFF cycling. * Retighten the arbor bolt if it is loose. * Replace the brushes if they are cracked or damaged.
Why is the angle of cut not accurate on my Craftsman 137.21236 Saw and I cannot adjust the miter?
If the angle of cut is not accurate and you cannot adjust the miter on your Craftsman Saw: * See the Miter Angle Adjustment section, as the miter table might be unlocked. * Vacuum or blow out dust, while wearing eye protection, as there may be sawdust under the table.
What to do if my Craftsman 137.21236 Saw cutting arm will not fully raise, or blade guard won’t fully close?
If the cutting arm on your Craftsman Saw will not fully raise, or the blade guard won’t fully close: * Loosen the pivot bolt lock nut (see adjustment section) if the pivot bolt is too tight. * Clean and lubricate moving parts, as sawdust build-up may be the cause.
Why does my Craftsman Saw brush spark when switch released?
If your Craftsman Saw brush sparks when the switch is released, replace the brushes, as they may be worn.
Explains various pictorial warning symbols used in the manual.
Step-by-step instructions for blade replacement.
Detailed process for correctly mounting a new saw blade.
How to ensure the fence is perpendicular to the blade.
How to use the scale for setting miter angles accurately.
Adjusting the vertical travel depth of the cutting arm.
How to adjust the saw's bevel angle stops.
Instructions for securely mounting the saw to a workbench.
Key safety precautions before and during saw operation.
Checklist of items to inspect before operating the saw.
To Next Page
General