To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 137.212940 and is the answer not in the manual?
General| Model Number | 137.212940 |
|---|---|
| Type | Table Saw |
| Arbor Size | 5/8 inch |
| Motor | 15 Amp |
| No Load Speed | 5000 RPM |
| Bevel Capacity | 0 to 45 degrees |
| Depth of Cut at 90 degrees | 3 inches |
| Blade Diameter | 10 inches |
Key specifications and identification of the sliding compound mitre saw.
Critical caution statement before using the mitre saw.
Details the terms of the two-year warranty for defects in material or workmanship.
Detailed technical specifications of the sliding compound mitre saw.
Essential safety advice and precautions to follow before operating the saw.
Critical safety rules for operating the sliding mitre saw safely.
Procedures and checks to perform before starting any cutting operation.
Safety precautions to observe while the mitre saw is in operation.
Details on the saw's electrical power source and motor specifications.
Recommendations for selecting and using appropriate extension cords.
Information on accessories that should not be used and those that are recommended.
Instructions for unpacking and verifying all parts received in the saw package.
A labelled diagram identifying all parts of the sliding mitre saw.
Definitions of terms specific to the saw and general woodworking.
Tools required for assembly and important safety warnings before starting.
Step-by-step instructions for assembling the mitre saw and its components.
Critical steps for safely changing the saw blade.
Instructions for installing the table insert and the anti-tip support bracket.
How to adjust the mitre settings and scale indicator for accuracy.
Adjusting the sliding carriage and ensuring blade squareness to the fence.
Procedures for calibrating the bevel stops for 90 and 45-degree cuts.
Adjusting sliding bars, pivot points, and cutting head travel.
Adjusting cutting depth and instructions for mounting the mitre saw.
Guidelines for safely moving and storing the sliding compound mitre saw.
Proper body and hand positioning for safe and effective saw operation.
Step-by-step guides for performing common cutting operations like mitre and crosscuts.
Instructions for slide cuts, bevel cuts, compound cuts, and dado cuts.
Techniques for workpiece support and cutting various molding types.
Detailed instructions for accurately cutting crown molding.
Procedures for cleaning sawdust, lubricating parts, and replacing carbon brushes.
Solutions for common motor problems and general operational issues.
Guidance on how to order specific replacement parts using their I.D. numbers.
