!F'----
STCI_IING 'THE T -WR_H (FIGURE FI 2
The li7llt rea; s_e ol 1.11escroll saw bc_7 (1) has a
U-shaped he_der(2) designed [o slore l.he T-wrerlch (,_3},
_sitI_ the shall of Me T-w_enc_l handle inlo _'_e_uFJer
Fig. F
3
2
%
J
/
B_DE REMOVAL AND INSTALLATION
PLAIN-END BLADE REMOVAL AND
|N,STA LLAT_ON
L_sen _he u_per bl_d_ hoist 4"3/_F tumir_gthe se_
_e,,,_(4)counlerclo_w_ wlh 'the T-wren_ 15)
Fig, H
3
\
& Lo_er_ the _ower Blade Bolde¢ [£i} #y ir_rbn# I_e
T-e_rench (5) u_der _het_ble, and hJrai_ !_ set
scr_ (7_coun_e¢_ockwis8 {FIG_ H),
4. Re_ _hebla_ {1) _am 1_ upper (3) and !ewe{ [_)
Made r_31de[sbz i%_lte#_¢rwar_ _ ItA_g _he b_de
LhroughI_ _Dcess hole (8] _ t:het_l_e (_G_ |)-
Fig, !
This s¢_o!__w a_epts 5 i_h plato,an# aad pln-_d
t_yp_bl_e$ to ,cu_& wi_ variety el _a_eria{_
Pl_ir_-_ !_e blade_ _re recommended wbe_e_r _ir_o=
accurate, an# in1#ca_e_¢k is being paderm_ on 3_'4'
or _hin_er malerisl Ir wiI_l_ke s_g!'_[o_ger to astal _e
Blade Wl[h proper 1.ensl_, bet _u w_l a_se be _Ble le
use _in_ t_]_des cu_tir_g_ sma_e_ kerr i_ I_e v_or_D!_,
Te _vo_d l_jU_y _rom a¢_den[a s_rl _g, _lwayS {urn #_
switch eft a_ _emove the #_r COrd p_a# f¢om 1he
po'#_er _eur_e _'_ore _mo'_,_r}gor _e_aci_g '_ffeb_ar_.
PLAI_N-Et,ID BLAIDE _NSTALLATI,ON (FIGILIR_ _,j, _)
1he _able. (F|G. li)
CAU_ON: In o_der to ave_d u_coc_tr_led Idling el
PLA|N-_ND BLADE _EMOVAL (FIGURE G_H, !) tb_ workpiece, |be _eeth _f _he b_s_ should
1. T_ _emeve _heb._d_ (I)_ I_sen the [ensi_ o_ the
b_ar_eby_ifl_a#upl_e.qu_oteLe_tar_si_16_,e_(2_ 2. l_s_rL_heblade[1}_n_l_rblade holderslc4
_abb ar_Jtum;iag [he se_sc_¢,, [7) clc_kwi_ [RG, J).
Fig. G
Fig. J
\
.,-5
w
111
To Next Page
Loading...
Need help?
General
