How to fix a Craftsman 247.88690 when the engine fails to start?
If your Craftsman Snow Blower engine fails to start, make sure of the following: 1. Move the choke control to the ON position. 2. Connect the wire to the spark plug. 3. Clean, adjust the gap, or replace the spark plug. 4. Fill the tank with clean, fresh gasoline. 5. Prime the engine as instructed in the Operation Section. 6. Insert the key fully into the switch.
What to do if Craftsman Snow Blower engine runs erratically?
If your Craftsman Snow Blower engine runs erratically, try the following: Move the choke control to the OFF position. Refill the fuel tank with clean, fresh gasoline. Drain the fuel tank and refill it with fresh fuel. If the problem persists, contact your Sears Parts & Repair Center for assistance with carburetor adjustments.
What to do if my Craftsman Snow Blower doesn't move?
If your Craftsman Snow Blower unit fails to propel itself, you can try the following: Adjust the drive control cable, referring to the Service and Maintenance section for guidance. Replace the drive belt, also referring to the Service and Maintenance section. If these steps don't resolve the issue, you may need to change the friction wheel or contact your Sears Parts & Repair Center.
What to do if my Craftsman 247.88690 Snow Blower fails to discharge snow?
If your Craftsman Snow Blower fails to discharge snow, there might be several reasons. First, the chute assembly could be clogged; immediately stop the engine, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing using a clean-out tool or a stick. Second, a foreign object might be lodged in the auger; in this case, stop the engine immediately, disconnect the spark plug wire and remove the object from the auger using a clean-out tool or a stick. Third, the auger cable may need adjustment; refer to the Assembly section for instructions. Fourth, the auger belt could be loose or damaged; in that case, replace the auger belt, referring to the Service and Maintenance section. Finally, the shear pins might be sheared; replace them with new ones.
Why is my Craftsman 247.88690 losing power?
If your Craftsman Snow Blower is losing power, check the following: Ensure the spark plug wire is securely connected and tightened. Also, inspect the gas cap to ensure the vent hole is clear of any obstructions like ice or snow. Make sure the vent hole is clear.
General| Brand | Craftsman |
|---|---|
| Model | 247.88690 |
| Category | Snow Blower |
| Language | English |
To Next Page