Craftsman 316.35084 - User Manual

Questions and Answers

A
Austin BenderJul 29, 2025
What to do if my Craftsman 316.35084 unit won't start?
- J
  Jenna FritzJul 29, 2025
  If your Craftsman Chainsaw doesn't start, several factors could be the cause. Ensure you are following the correct starting procedures. Check and fill the fuel tank with properly mixed fuel. Clean, gap, or replace the spark plug if it's fouled. Also, make sure you press the primer bulb fully and slowly 10 times. If the issue persists, the carburetor mixture adjustment setting may be incorrect, and you may need to have it adjusted by a qualified service dealer.
J
Jamie SchultzAug 3, 2025
How to fix a Craftsman 316.35084 that runs erratically?
- P
  pbrownAug 3, 2025
  If your Craftsman Chainsaw runs erratically, consider these potential causes: * The spark plug may be incorrectly gapped (clean/gap or replace the plug). * The spark arrestor may be plugged (clean or replace the spark arrestor). * The air filter may be dirty (clean or replace the air filter).
T
Tammy HughesAug 8, 2025
What to do if my Craftsman 316.35084 has no power under load?
- W
  wallsmichelleAug 8, 2025
  If your Craftsman Chainsaw has no power under load, the possible reasons are: the carburetor mixture adjustment setting may be incorrect (in this case you may need to have it adjusted by a qualified service dealer), you might be using old or improperly mixed fuel (drain the gas tank and add fresh fuel mixture), the air filter might be plugged (replace or clean the air filter), the spark plug might be fouled (replace or clean the spark plug).
M
Makayla WestAug 13, 2025
Why does my Craftsman Chainsaw engine hesitate?
- B
  Brandi MarksAug 14, 2025
  If your Craftsman Chainsaw engine hesitates, this could be due to several reasons. The carburetor mixture adjustment setting may be incorrect, and you may need a qualified service dealer to adjust it. Another reason might be that the air filter is plugged, so replace or clean it. Also, check if you are using old or improperly mixed fuel; if so, drain the gas tank and add a fresh fuel mixture.
W
William WagnerAug 18, 2025
Why does my Craftsman 316.35084 Chainsaw smoke excessively?
- M
  Mary WeberAug 18, 2025
  If your Craftsman Chainsaw smokes excessively, it could be due to an incorrect carburetor mixture adjustment setting, which requires adjustment by a qualified service dealer. Another reason could be the use of incorrect fuel mixture; ensure you are using properly mixed fuel (40:1 mixture).
S
Spencer OsborneAug 23, 2025
Why does my Craftsman Chainsaw start but have low power?
- A
  Angela EdwardsAug 23, 2025
  If your Craftsman Chainsaw starts but has low power, the fuel filter may be plugged and needs replacement. Ensure the lever is in Position 3. A dirty spark arrestor screen can cause this issue, so replace it. Clean and reinstall the air filter if it's dirty. Also, the carburetor mixture adjustment setting may be incorrect, and you may need to have it adjusted by a qualified service dealer.