Craftsman 351.221140 User Manual

Owner" s anUal
N
1.5 Horsepower (continuous duty)
3450 R.P.iVl. (no load R.P.lVl.)
10-in. TA LE SAW
Model No.
351.221140
®
C US
CAUTION'.
FOR YOUR OWN SAFETY; Read
and follow all of the Safety and
Operating Instructions before
Operating this Table Saw.
Customer Helpline
1-800-266-9079
Please have your Model No.
and Serial No. available.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Part No. OR91551
VER. 9.08 EspaSol pg. 49

Craftsman 351.221140 Specifications

General

Motor	15 Amp
Arbor Size	5/8 inches
No Load Speed	5000 RPM
Blade Diameter	10 inches
Dust Port Size	1-1/4 inches

Summary

Safety Instructions

General Safety Instructions

Discusses fundamental safety rules, environment, clothing, and personal protection.

Guidelines for Extension Cords

Specifies requirements and recommendations for using extension cords safely.

Grounding Instructions

Explains the importance and procedure for grounding the table saw.

Specific Safety Instructions for Table Saws

Provides detailed safety measures specific to table saw operations.

Before Using the Table Saw

Details critical pre-operation checks and warnings.

General Operating Precautions

Electrical Safety

Covers electrical shock prevention and cord safety.

Safety Guidelines

Covers numbered safety points 1-17 for safe operation.

Know Your Table Saw

Assembly Instructions

Rip Fence Assembly

Provides instructions for assembling the rip fence.

On/Off Switch Assembly

Miter Gauge Assembly

Cabinet Leg Assembly

Connecting Switch Cord

Blade Guard and Splitter Assembly

Operations and Adjustments

Locking On/Off Switch

Tilting the Blade

Instructions for tilting the blade to different angles.

Changing the Saw Blade

Miter Gauge Operation

Thermal-Overload Protection

Motor overload protection and reset procedure.

Adjusting Blade Bevel Stops

Checking Blade Alignment

How to check blade alignment with miter slots.

Changing Motor Voltage

Aligning Splitter Bracket

Clamp and Fence Stop Operation

Raising and Lowering the Blade

How to adjust the blade height.

Rip Fence Operations and Adjustments

Aligning Blade Parallel to Miter Slot

Steps to ensure blade is parallel to miter slots.

Adjusting Fence Slide

How to ensure the fence slides smoothly.

Adjusting Rip Fence Parallel

Steps to make fence parallel to miter groove.

Rip Fence Micro-Adjustment

Adjusting Rip Fence Square

Cross Cutting

Performing Crosscuts

Ripping

Ripping Operation

Dado Blade Set

Dadoing Operation

Molding Head Cutter

Maintenance

Backlash Adjustments

Protecting Cast Iron Table

Troubleshooting Guide

Motor Issues

Addresses problems like motor not starting or stalling.

Blade and Fence Alignment

Solutions for blade/fence issues and vibrations.