To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 875.191170 and is the answer not in the manual?
General| Model Number | 875.191170 |
|---|---|
| Type | Circular Saw |
| Blade Diameter | 7-1/4 inches |
| Motor | 15 Amp |
| No Load Speed | 5500 RPM |
| Cord Length | 6 feet |
| Bevel Capacity | 56 degrees |
| Depth of Cut at 45 degrees | 1-3/4 inches |
| Product Type | Circular Saw |
| Corded/Cordless | Corded |
| Depth of Cut at 90 degrees | 2-7/16 inches |
| Amperage | 15 Amp |
Read instructions, use proper eye/hearing protection, avoid vibration, and maintain correct air pressure.
Adhere to 90 PSIG maximum; use only impact sockets and check for wear.
Provides a two-year warranty for satisfaction, with a 90-day limit for commercial use.
Highlights a lever throttle, low profile head for tight spaces, and front exhaust.
Details torque, air inlet, pressure, speed, consumption, drive size, weight, and hose size.
Ensure air hose is clear and air supply is shut off before servicing or changing sockets.
Use clean, dry air at 90 psi; recommend installing a filter-regulator-lubricator.
Lever throttle controls speed; use manually for initial tightening/loosening fasteners.
Keep socket firm on anvil to prevent dislodging; direction control is on the ratchet head.
Use in-line filter-regulator-lubricator, check and fill with air tool oil regularly.
Lubricate generously before extended storage; store in a clean, dry area.
Use air tool oil or turbine oil with specific additives for optimal performance.
Addresses slow operation or non-operation due to grit, oil, pressure, leaks, or worn parts.
Water in exhaust indicates tank moisture; drain tank and lubricate tool properly.
