To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 875.50190 and is the answer not in the manual?
General| Model Number | 875.50190 |
|---|---|
| Type | Angle Grinder |
| Voltage | 120V |
| Corded/ Cordless | Corded |
| Amperage | 7.5A |
| Spindle Size | 5/8-11 in |
| Wheel Diameter | 4.5 inches |
| Wheel Thickness | 1/4 inch |
| Arbor Size | 5/8 inch |
Jack supports up to 1500 lbs for motorcycles and ATVs.
Features a hydraulic pump with foot pedal for easy lifting.
Provides positive locking at three different lift heights.
Comes with two 1-inch wide x 15-foot long ratcheting tie-down straps.
Two 2-inch adapter plates sold separately to increase max lift height.
Detailed steps for safely lifting a vehicle using the jack.
Procedure for safely lowering a vehicle after lifting.
Instructions for using included tie-down straps to secure the vehicle.
Procedure for safely releasing the vehicle from the tie-down straps.
Instructions for adding the correct type and amount of hydraulic oil.
Steps for draining old oil and refilling the hydraulic system.
Guidance on lubricating moving parts as needed.
Recommendations for storing the jack when not in use.
Checks for rust and corrosion on the hydraulic unit.
Troubleshooting steps for when the jack fails to lower fully.
Solutions for the jack not reaching its maximum lifting height.
Diagnosing and fixing issues causing the jack to lift weakly.
Resolving problems where the jack cannot lift the intended weight.
