Craftsman CMCS4000 User Manual

9
ENGLISH
Fig.K
On/Off Switch (Fig. L, M)
• To turn the wet tile saw on, lift up the on/off switch
1
.
• The wet tile saw locks onautomatically.
• To turn the tool off, push the on/off switchdown.
NOTE: A removable safety lock
26
can be removed to
deter unauthorizeduse.
Fig.L
1
Fig.M
26
Filling and Draining the Water Reservoir
(Fig. N)
1. Plug the water reservoir drain hole
21
with the
drain plug
22
. Secure the drain plug into position
by tightening the attached wing nut
23
as shown in
FigureN.
2. Slowly fill the water reservoir to the MIN fill line
24
, to
prevent accidental overfilling. Do not fill above the MAX
fill line
25
.
3. To drain the reservoir, p
lace a 5 gallon (19liter) bucket
under the drainplug.
4. Remove the drain plug by loosening the attached wing
nut and allow the water to empty into thebucket.
Fig.N
21
22
23
24
25
Making a Cut (Fig. A)
Verify the proper alignment of the cutting cart and blade
before turning the saw on.
Always keep hands away from theblade.
1. Lift the On/Off switch
1
to turn the saw on. Wait until
the stream of water completely covers theblade.
NOTE: Cutting tile without water will damage theblade.
2. Ease the cutting cart toward the blade then slowly feed
the tile into the blade. Continue pushing until the blade
cuts completely through thetile.
3. Turn the saw off by pushing the On/Off switch
1
down.
4. After the blade stops, remove the tile and remnant from
the cuttingcart.
Locking the Cutting Cart (Fig. O)
There is one locking position for thecart.
Move the cart to the lock position and lock the cart by
pushing the pin
3
into a hole in therail.

Craftsman CMCS4000 Specifications

General

Brand	Craftsman
Model	CMCS4000
Category	Saw
Language	English