Craftsman CMCS4000 - Removal and Installation of the Cutting Cart (Fig. A, P, Q); Types of Cuts (Fig. A, S); L-Cuts; Adjustments (Fig. A, S)

ENGLISH
10
Fig.O
3
Removal and Installation of the Cutting
Cart (Fig. A, P, Q)
To Remove the Cutting Cart
1. Unlock the cutting cart stop
8
.
2. Slide the cutting cart off thetool.
Fig.P
Fig.Q
To Install the Cutting Cart (Fig. R)
1. Align rail guide rollers
26
on the cutting cart to the
rails
27
on the tool. Make sure the cutting cart lock pin
is in the unlockposition.
2. Slide the cutting cart onto thetool.
3. Lock the cutting cartstop.
Fig. R
27
26
Types of Cuts (Fig. A, S)

WARNING: Do not make freehandcuts.
Always do a practice run to acquaint yourself with the path
of the blade. Practice on a scrap tile to ensure that you are
comfortable with the feel of the cutting operation. Push the
cart past the blade before turning the sawon.
Straight Cuts
1. Using a marker or grease pencil, mark the area to be cut
ontile.
2. Place the tile on the cutting cart against the cutting cart
fence
7
and align your mark with theblade.
3. Pull the on/off switch up to turn the saw on and wait for
the blade to be completely covered withwater.
4. Ease the cutting cart toward the blade then slowly feed
the tile into the blade. Continue pushing until the blade
cuts completely through thetile.
NOTE: The flip hood on the splash hood can be rotated
up to help align the line on the tile with the blade.
5. Turn off thesaw.
Diagonal Cuts
Diagonal cuts are also referred to as “long point to long
point cuts.”
1. Install the edge guide.
2. Align the point of the tile closest to the cutting cart
fence
7
with the cut indicator
30
.
3. Align the front of the tile to the blade and hold against
the edge guide.
4. Turn the saw on and make thecut.
5. Turn off thesaw.