13
ENGLISH
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not start. Battery pack not installed properly. Check battery pack installation.
Battery pack not charged. Check battery pack charging requirements.
Unit starts immediately upon inserting battery. The switch has been left in the “on” position. The switch must be moved to “off” to prevent
the tool from immediately starting when battery
is inserted.
Battery pack will not charge. Battery pack not inserted into charger. Insert battery pack into charger until LED lights.
Charger not plugged in. Plug charger into a working outlet. Refer to
Important Charging Notes for more details.
Surrounding air temperature too hot or too cold. Move charger and battery pack to a surrounding
air temperature of above 40 °F (4.5 °C) or below
104 °F (+40 °C).
Unit shuts off abruptly. Battery pack has reached its maximum
thermal limit.
Allow battery pack to cool down.
Out of charge. (To maximize the life of the
battery pack it is designed to shutoff
abruptly when the charge is depleted.)
Place on charger and allow to charge.
To Next Page
Loading...
Need help?
General