Craftsman CMECS600 Instruction Manual

ENGLISH
10
possible. Position the log in a stable position. Always cut on
the outside of the saw horse arms.
Fig. N
1. Always start a cut with the saw chain running at
fullspeed.
2. Place the bottom spike
22
of the chain saw behind the
area of the initial cut as shown in FigureO.
3. Turn the chain saw on then rotate the saw chain and bar
down into the tree, using the spike as ahinge.
4. Once the chain saw gets to a 45° angle, level the chain
saw again and repeat steps until you cut fullythrough.
5. When the tree is supported along its entire length, make
a cut from the top (overbuck), but avoid cutting the
earth as this will dull your sawquickly.
CUT FROM TOP (OVERBUCK)
AVOID CUTTING EARTH
Fig. O
22
• FigureP- When supported at one end
First, cut 1/3 the diameter from the underside
(underbuck). Then make the finishing cut by
overbucking to meet the firstcut.
1
1
2
2nd CUT OVERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)
1st CUT UNDERBUCK
(1/3 DIAMETER)
AVOID SPLINTERING
Fig. P
• FigureQ- When supported at bothends. First, cut 1/3
down from the top overbuck. Then make the finished
cut by underbucking the lower 2/3 to meet the firstcut.
2nd CUT UNDERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)
1st CUT OVERBUCK
(1/3 DIAMETER)
TO AVOID SPLINTERING
Fig. Q
• When on a slope always stand on the uphill side of the
log. When “cutting through”, to maintain complete
control reduce the cutting pressure near the end of the
cut without relaxing your grip on the chain saw handles.
Don’t let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move
the chain saw. Always stop the motor before moving
from cut tocut.
Fig. R
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Accessories

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Repairs

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including power cord repairs, and brush inspection
and replacement, when applicable) should be
performed by a CRAFTSMAN factory service center or
a CRAFTSMAN authorized service center. Always use
identical replacementparts.

Craftsman CMECS600 Specifications

General

Brand	Craftsman
Model	CMECS600
Category	Chainsaw
Language	English