Craftsman CMXGMAM1125500 User Manual

778-15620© 2018 11A-B2RQ CRAFTSMAN and the CRAFTSMAN logo are trademarks of Stanley Black & Decker, Inc. or an affiliate thereof and are used under license.
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Wing Nuts
A. Remove the wing nuts and carriage bolts
securing the upper handle to the lower
handle.
Pivot the upper handle
upward.
A. Insert the T-bolts removed in Step 1B
through the handle brackets to secure
the handle in place.
A. Hold blade control handle against upper handle.
B. Slowly pull starter rope handle from engine and
slip starter rope into the rope guide.
C. Tighten rope guide wing knob.
D. Use cable tie to secure cables to lower handle.
A
B
C
D
Starter
Rope Handle
Blade Control Handle
B. Remove T-bolts from
the handle brackets.
T-Bolt
B
A
A
B
B
B. Secure upper handle
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
Pull upward on the
handle until the holes
in lower handle line up
with the holes
in the handle bracket.
A
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
Fast Start Guide - Engine Start
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
and FOLLOW THE important SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help?
www.CRAFTSMAN.com or Call 1-888-331-4569

Craftsman CMXGMAM1125500 Specifications

General

Cutting Width	21 inches
Power Source	Gas
Deck Material	Steel
Starting System	Recoil
Weight	64 lb
Engine Brand	Briggs & Stratton
Drive Type	Self-Propelled
Start Type	Recoil
Number of Cutting Positions	6
Mulching Capability	Yes
Side Discharge	Yes
Rear Bag	Yes
Cutting Positions	6
Speed Settings	Variable
Bagging Capability	Yes
Side Discharge Capability	Yes
Engine Type	Gas
Cutting Height	1.25-3.75 inches
Wheel Size	8 inches

Summary

Handle Assembly and Preparation

Prepare Handle for Attachment

Remove wing nuts, carriage bolts, and T-bolts from handle brackets for assembly.

Pivot and Align Upper Handle

Swing upper handle upward and align holes with bracket for connection.

Secure Handle Assembly

Insert T-bolts and secure the upper handle to the lower handle with hardware.

Engine Starting Procedure

Initiate Engine Start Sequence

Hold blade control, pull starter rope, adjust choke, and secure cables for starting.

Add Engine Oil

Pour the entire SAE 10W 30 oil bottle into the engine's oil fill.

Add Fuel and Open Valve

Fill the fuel tank and turn the fuel valve to the open position.

Execute Engine Start Pull

Pull the starter rope handle with a quick, full-arm stroke to start the engine.