Craftsman CMXGMAM2703841 User Manual (English)

Questions and Answers:

M
Miranda CarterAug 16, 2025
Why won't my Craftsman Lawn Mower start?
- A
  Amanda ArnoldAug 16, 2025
  Several factors could prevent your Craftsman Lawn Mower from starting. Ensure the blade control is engaged and the spark plug boot is connected. Check if the fuel tank is empty or contains stale fuel; if so, refill with fresh gasoline. If your mower has a primer, prime the engine as instructed. Inspect the spark plug for faults and clean, adjust the gap, or replace if necessary. If the engine is flooded, wait a few minutes before restarting. Finally, a blocked fuel line could be the issue, in which case you should contact your Parts & Repair Center to have it cleaned.
K
kristin43Aug 19, 2025
What to do if Craftsman Lawn Mower with electric starter fails to start?
- C
  cwelchSep 12, 2025
  If your Craftsman electric start lawn mower isn't starting, make sure the Electric Starter Push Key is fully inserted until it snaps into place. Also, ensure the battery is charged by referring to the Battery Charger Instructional Manual. Finally, if the circuit breaker tripped, stop the engine, remove the Electric Starter Push Key, and disconnect the spark plug boot. Check for and carefully remove any grass or debris obstructing the blade. Reattach the spark plug boot and reinsert the Electric Starter Push Key. Wait one minute for the circuit breaker to automatically reset before trying to start again.
A
Amy RoachAug 22, 2025
Why is my Craftsman CMXGMAM2703841 Lawn Mower engine running erratically?
- R
  rsandersAug 22, 2025
  An erratic running engine in your Craftsman Lawn Mower can stem from several causes. First, check that the spark plug boot is securely connected and tightened. Stale fuel can also cause this issue, so replace it with fresh gasoline. Ensure the vent in the gas cap isn't plugged. Water or dirt in the fuel system might be the culprit; run the engine until it stops from lack of fuel, then refill with fresh fuel. If the air cleaner is dirty, refer to the Engine Manual for Air Cleaner Maintenance instructions. Lastly, a blocked fuel line could be the problem, requiring professional cleaning.
T
Tiffany FordAug 26, 2025
Why won't my Craftsman Lawn Mower self propel?
- J
  Janice EvansAug 26, 2025
  If your Craftsman Lawn Mower isn't self-propelling, check the belt for proper pulley installation and movement. Clear any debris clogging the drive operation by stopping the engine and disconnecting the spark plug boot before cleaning. Inspect the belt for damage or wear, and consider having it replaced. Also, the drive control might be out of adjustment, refer to page 10 in the Assembly & Set-up section for adjustment instructions.
D
Dr. Darrell Roberts MDAug 28, 2025
Why does my Craftsman Lawn Mower leave an uneven cut?
- E
  edward66Aug 28, 2025
  An uneven cut with your Craftsman Lawn Mower can be caused by a few things. Make sure the wheels are positioned correctly by adjusting the cutting height lever on the right front and right rear wheels to the same position. Also, a dull blade can contribute to an uneven cut, so sharpen or replace it.
E
elizabeth70Aug 31, 2025
What to do if my Craftsman CMXGMAM2703841 engine overheats?
- M
  Melissa GonzalezAug 31, 2025
  If your Craftsman Lawn Mower engine is overheating, start by checking the engine oil level and fill the crankcase with the proper oil if it's low. Also, ensure that there are no restrictions to air flow around the engine by cleaning the area around and on top of it.
E
Elizabeth JohnsonSep 3, 2025
How to reduce excessive vibration in my Craftsman CMXGMAM2703841 Lawn Mower?
- A
  Anthony GarciaSep 3, 2025
  Excessive vibration in your Craftsman Lawn Mower could be due to a loose or unbalanced cutting blade. Try tightening the blade and adapter, and balance the blade. If the cutting blade is bent, it will need to be replaced.
N
Natasha CalderonSep 6, 2025
Why isn't my Craftsman CMXGMAM2703841 mulching grass properly?
- L
  leah08Sep 6, 2025
  If your Craftsman Lawn Mower isn't mulching grass effectively, it could be due to wet grass; avoid mowing in wet conditions and wait for the grass to dry. Excessively high grass can also hinder mulching, so mow once at a high cutting height, then mow again at the desired height or make a narrower cutting path. Finally, a dull blade will impact mulching performance, so sharpen or replace it.
S
Shawn RyanSep 9, 2025
Why does my Craftsman Lawn Mower idle poorly?
- H
  Holly PerezSep 9, 2025
  Poor idling in your Craftsman Lawn Mower can be attributed to a spark plug that is fouled, faulty, or has a gap that is too wide; reset the gap or replace the spark plug. Another potential cause is a dirty air cleaner, in which case you should refer to the Engine Manual for Air Cleaner Maintenance.
S
Samuel CastilloSep 12, 2025
What causes occasional skips in my Craftsman CMXGMAM2703841?
- M
  Miranda MorganSep 12, 2025
  Occasional skipping or hesitation in your Craftsman Lawn Mower could be due to a spark plug gap that is too close. Adjust the gap, referring to the Spark Plug Maintenance section in the Engine Manual.