Craftsman S185 - User Manual

Questions and Answers

E
ethan40Aug 13, 2025
Why won't my Craftsman S185 Chainsaw engine start?
- D
  Donald AlvaradoAug 13, 2025
  Your Craftsman Chainsaw engine might not be starting due to several reasons: * The fuel tank could be empty; if so, fill it with properly-mixed fuel. * You might not have pressed the primer bulb enough; press it 10 times or until fuel is visible. * The engine could be flooded; in this case, move the choke knob to Position 2, press the throttle lockout, squeeze the throttle control, and pull the starter rope. * The fuel might be old (over 30 days) or improperly mixed; drain the fuel tank and add fresh, properly-mixed fuel.
C
Cathy ValentineAug 16, 2025
What to do if the Craftsman S185 Chainsaw guide bar and saw chain are running hot and smoking?
- M
  Michael RodriguezAug 16, 2025
  If the guide bar and saw chain are running hot and smoking, consider the following: * The saw chain tension might be too tight; adjust the saw chain tension. * The chain oil reservoir could be empty; refill it. * The guide bar groove and oil passages may be dirty; clean them. * The automatic oiler flow might be too low; increase the oil flow.
I
imurrayAug 20, 2025
What to do if my Craftsman Chainsaw saw chain does not rotate?
- J
  Jennifer CollinsAug 20, 2025
  If the saw chain on your Craftsman Chainsaw does not rotate, check the following: * The saw chain tension might be too tight; adjust it. * The chain brake may be engaged; disengage the chain brake. * Inspect the guide bar and saw chain for damage. Replace them if necessary.
I
Isaiah AlexanderAug 25, 2025
Why won't my Craftsman Chainsaw engine idle?
- E
  Emily WoodsAug 25, 2025
  If your Craftsman Chainsaw engine won't idle, it could be due to: * A dirty air filter: Clean or replace the air filter. * Old or improperly mixed fuel: Drain the fuel tank and add fresh, properly-mixed fuel. * Incorrect idle speed: Adjust the idle speed.
K
Katherine BassAug 27, 2025
What to do if my Craftsman S185 engine lacks power or stalls?
- X
  xfrederickAug 27, 2025
  If your Craftsman Chainsaw engine lacks power or stalls, it could be due to: * Old or improperly mixed fuel: Drain the fuel tank and add fresh, properly-mixed fuel. * A dirty air filter: Clean or replace the air filter.
E
Elizabeth StephensonAug 31, 2025
Why Craftsman S185 Chainsaw engine will not accelerate?
- H
  howardlaurenAug 31, 2025
  If your Craftsman Chainsaw engine will not accelerate, the possible causes are: * The fuel is old (over 30 days) and/or improperly mixed, so drain the fuel tank and add fresh, properly-mixed fuel. * The air filter is dirty, so clean or replace the air filter.
J
Justin FoleySep 4, 2025
What to do if the saw chain on my Craftsman S185 comes off the guide bar?
- E
  elizabethgreenSep 5, 2025
  If the saw chain keeps coming off the guide bar, it might be because the saw chain tension is too loose. Adjust the saw chain tension to resolve this issue.
H
Holly LongSep 8, 2025
What to do if Craftsman Chainsaw saw chain rotates, but does not cut?
- E
  Eddie ReedSep 8, 2025
  If the saw chain rotates but does not cut, it may be because the saw chain is dull, so sharpen or replace it. Another reason may be that the saw chain is on backwards, so check and correct the saw chain direction.