Craftsman T100 Series - Page 11

11
ASSEMBLY
Once the hood topper is in place, the two locking tabs (a) near the rear of the hood
need to be pushed upward to lock the hood topper in place. See Figure 9.
Hood Topper Not Shown for Clarity
Figure 9
Installing the Screw-On Hood Topper (If necessary)
Note: Be careful not to damage the headlight harness when installing the screw-on
hood topper.
Set the hood topper up against the top of the hood with the hood open, and align
the holes on the hood.
Secure the screw-on hood topper (a) from below, hand-tighten the screws (b) on
the rear half of the hood and then snug them. See Figure 10.
With the rear screws in place, align the holes in the hood topper (a) with the holes
in the hood (c) and secure in place with remaining two screws (d). See Figure 10.
Tighten all four screws to 16-24 in-lbs.
(a)
(b)
(b)
(d)
(c)
(d)
Figure 10
Use these alignment points to properly position the hood collar (a) and then secure
it in place with the six hex bolts (b) provided in the hardware bag. See Figure 7.
Tighten the hex bolts to 102-124 in-lbs.
b
b
b
b
a
Figure 7
Installing the Snap-On Hood Topper (If necessary)
To install the hood topper (a), line up the holes on the hood topper (a) up with the
tabs (b) in the hood frame as shown in Figure 8. Insert the tabs (b) into the hood
topper and pull back to lock into place.
(a)
(b)
(b)
(b)
(b)
Figure 8