To Next PageTo Next Page
Need help?Do you have a question about the Craftsman WC205 and is the answer not in the manual?
General| Power Source | Gas |
|---|---|
| Cutting Width | 17 inches |
| Line Diameter | 0.095 inches |
| Line Feed | Bump feed |
| Engine Type | 2-cycle |
| Engine Displacement | 25 cc |
| Shaft Type | Straight |
Key safety precautions for operating the unit.
Specific safety measures for gasoline-powered units.
Explanation of safety alert symbols and pictographs used.
Describes the intended uses and applications of the trimmer.
Lists the tools needed for unit assembly.
Step-by-step instructions for attaching the cutting head shield.
Guide for connecting and disconnecting unit attachments.
Proper ratio and method for mixing fuel and oil.
Safe procedures for filling the fuel tank.
Detailed steps for starting the engine.
Instructions on how to safely stop the engine.
Proper grip and stance for operating the unit.
How to extend the trimming line using the bump head.
Advice for optimal cutting performance.
Technique for trimming around trees and posts.
Guide for using the unit for edging tasks.
Recommended maintenance tasks and frequencies.
Procedure for removing and replacing trimmer line.
Instructions for winding a single trimming line.
Instructions for winding split trimming line.
Steps to install the wound inner reel into the cutting head.
Cleaning and servicing the air filter.
How to adjust the engine's idle speed.
Cleaning, gapping, and replacing the spark plug.
How to clean the exterior of the unit.
Guidelines for short-term and long-term storage.
Explains the terms and scope of the limited warranty.
Lists items and conditions not covered by the warranty.
