inthecarburetorbystartingtheen-
gineandlettingitrununtilitstops.
• Storeunitandfuelinareawherefuel
vaporscannotreachsparksoropen
flamesfromwaterheaters,electric
motorsorswitches,furnaces,etc.
• Storeunitsolinelimiterbladecannot
accidentallycauseinjury.Theunit
canbehungbythetube.
• Storeunitoutofreachofchildren.
Thisunitisnotequippedwithananti-
vibrationsystemandisintendedfor
occasionaluseonly.
SAFETYNOTICE:Exposuretovibra-
tionsthroughprolongeduseofgaso-
linepoweredhandtoolscouldcause
bloodvesselornervedamageinthe
fingers,hands,andjointsofpeople
pronetocirculationdisordersorab-
normalswellings.Prolongedusein
coldweatherhasbeenlinkedtoblood
vesseldamageinotherwisehealthy
people.Ifsymptomsoccursuchas
numbness,pain,lossofstrength,
changeinskincolorortexture,orloss
offeelinginthefingers,hands,or
joints,discontinuetheuseofthistool
andseekmedicalattention.
Ananti-vibrationsystemdoesnot
guaranteetheavoidanceofthese
problems.Userswhooperatepower
toolsonacontinualandregularbasis
mustmonitorcloselytheirphysical
conditionandtheconditionofthistool.
SPECIALNOTICE:Thisunitis
equippedwithatemperaturelimiting
mufflerandsparkarrestingscreen
whichmeetstherequirementsofCali-
forniaCodes4442and4443.AllU.S.
forestlandandthestatesofCalifornia,
Idaho,Maine,Minnesota,NewJersey,
Oregon,andWashingtonrequireby
lawthatmanyinternalcombustionen-
ginesbeequippedwithasparkarrest-
ingscreen.Ifyouoperateinalocale
wheresuchregulationsexist,youare
legallyresponsibleformaintainingthe
operatingconditionoftheseparts.
Failuretodosoisaviolationofthe
law.Fornormalhomeowneruse,the
mufflerandsparkarrestingscreenwill
notrequireanyservice.After50hours
ofuse,werecommendthatyourmuf-
flerbeservicedorreplacedbyyour
SearsServiceCenter.
CARTONCONTENTS
Checkcartoncontentsagainstthefol-
lowinglist.
Model358.791010
• Trimmer
• Shield
• ContainerofOil
Examinepartsfordamage.Donot
usedamagedparts.
NOTE:Ifyouneedassistanceorfind
partsmissingordamaged,call
1-800-235-5878.
Itisnormalforthefuelfiltertorattlein
theemptyfueltank.
Findingfueloroilresidueonmuffleris
normalduetocarburetoradjustments
andtestingdonebythemanufacturer.
ASSEMBLY
_&WARNING: Always stop unit
and disconnect spark plug before per-
forming any assembly procedures.
_.WARNING: If received as-
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
ADJUSTING THE HANDLE
_& WARNING: When adjusting the
assist handle, be sure it remains above
the safety label and below the mark or
arrow on the shaft.
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an
upright position; retighten wing nut.
ATTACHING SHIELD
,_WARNING: The shield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
To Next Page
Loading...
Need help?
General