EasyManuals Logo

Craftsman WEEDWACKER 358.791010 User Manual

Craftsman WEEDWACKER 358.791010
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
WerecommendCraftsman'>brand
syntheticoil.Mixgasolineandoilata
ratioof40:1.A40:1ratioisobtained
bymixing3.2ouncesofoilwith1
gallonofunleadedgasoline.Included
withthistrimmerisa3.2ounce
containerofoil.Pourtheentire
contentsofthiscontainerinto1gallon
ofgasolinetoachievetheproperfuel
mixture.DONOTUSEautomotiveoilor
marineoil.Theseoilswillcause
enginedamage.Whenmixingfuel,
followinstructionsprintedon
container.
Onceoilisaddedtogasoline,shake
containermomentarilytoassurethat
thefuelisthoroughlymixed.Always
readandfollowthesafetyrules
relatingtofuelbeforefuelingyourunit.
IMPORTANT
Experience indicates that alcohol
blended fuels (called gasohol or using
ethanol or methanol) can attract mois-
ture which leads to separation and
formation of acids during storage.
Acidic gas can damage the fuel sys-
tem of an engine while in storage.
To avoid engine problems, empty the
fuel system before storage for 30 days
or longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh
fuel next season.
Never use engine or carburetor clean-
er products in the fuel tank or perma-
nent damage may occur.
See the STORAGE section for addition-
al information.
HOW TO STOP YOUR UNIT
To stop the engine, push and re-
lease the engine STOP switch. The
switch will automatically return to the
ON position. Wait 5 seconds before
attempting to restart unit to allow
switch to reset.
If engine does not stop, move choke
to the FULL CHOKE position.
HOW TO START YOUR UNIT
'_WARNING: Avoid any contact
with the muffler. A hot muffler can
cause serious burns.
_,b_/_L_. _ Starting,_d__'_P°siti°n
STARTING A COLD ENGINE
NOTE: DO NOT squeeze tile throttle
trigger until the engine has started and
runs.
1. Set unit on a fiat surface.
2. Slowly press the primer bulb 6
times.
3. Move the start lever to the START
position.
Primer
Start
Lever
Starter Handle
4= Pull starter rope handle with a con-
trolled and steady motion until en-
gine starts and runs.
5. Allow unit to run for 10-15 seconds,
then fully squeeze the throttle trigger
to disengage the starting system
(start lever returns to RUN position).
STARTING A WARM ENGINE
1. Squeeze and hold tile throttle trig-
ger. Keep throttle trigger fully
squeezed until engine runs
smoothly.
2. Pull starter rope handle with a con-
trolled and steady motion while
squeezing throttle trigger until en-
gine starts and runs.
NOTE: Normally, the warm starting
procedure can be used within 5-10
minutes after the unit is turned off. If
the unit sits for more than 10 minutes
without being used, it will be neces-
sary to start the unit by following the
steps under STARTING A COLD EN-
GINE or following the starting instruc-
tion steps shown on the unit.
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftsman WEEDWACKER 358.791010 and is the answer not in the manual?

Craftsman WEEDWACKER 358.791010 Specifications

General IconGeneral
BrandCraftsman
ModelWEEDWACKER 358.791010
CategoryTrimmer
LanguageEnglish

Related product manuals