Page 9 of 29
“Card Reader” - Card Reader Summary Error Codes
Press key number 4 and the display will show one of the following:
- “Card Reader Comm”, indicating no card reader communication for 5 seconds.
- “Card Reader #”, indicating the most recent “non-transient error” from the card reader (failed card reader).
Press key number 1 will return to “Card Reader” if all changer Error have not been cleared. If all card reader Error Codes
have been cleared the next error code will be displayed or “No Error Codes” if there are no Error Codes. Press key
number 1 will return to “Error Codes”. Press key number 2 will scroll to the next routine.
“OLM” – On Line Module Summary Error Codes
Press key number 4 and the display will show one of the following:
- “On Line Network”, error reported by the OLM.
- “On Line Internal”, error reported by the OLM.
Press key number 1 will return to “OLM” if all OLM Errors have not been cleared. If all OLM Error Codes have been
cleared the next error code will be displayed or “No Error Codes” if there are no Error Codes. Press key number 1 will
return to “Error Codes”. Press key number 2 will scroll to the next routine.
“Remote Vend Mech” - Remote Vend Mechanism (USD) Error.
Press key number 4 and the display shows one of the following.
- “Remote Vend Comm #”, indicates no communication for 5 seconds with remote vend mech at address “#”.
- “Remote Vend #”, indicates error code number “#” from the remote vend mech at address “a”.
Press key number 1 will return to “Remote Vend Mech” if all remote vend mechanism Error Codes have not been cleared.
If all remote vend mechanism Error Codes have been cleared the next error code will be displayed, or “No Error Codes”
if there are no Error Codes. Press key number 1 will return to “Error Codes”. Press key number 2 will scroll to the next
routine.
“Select/Display” - Selection / Display Device (ASD) Error
Press key number 4 and the display shows:
- “Select/Display Comm”, indicating no communication to selection / display device for five seconds.
Press key number 1 will return to “Select/Display” if all selection / display device Error Codes have not been cleared. If
all selection / display device error have been cleared the next error code will be displayed or “No Error Codes” if there
are no Error Codes.
Press key number 1 will return to “Error Codes”.
Press key number 2 will scroll to the next routine.
“Refrigeration” - Refrigeration Summary Error Codes
Press key number 4 and the display shows one of the following:
- “Temp Sense Err”, indicating the temperature sensor is defective or unplugged.
- “Temp Too Cold”, indicating the cabinet temperature is 3
0
F below lower limit.
- “Temp Too Hot”, indicating the cabinet temperature is 3
0
F above upper limit.
- “Not Cooling”, indicating the cooling system has failed to decrease temperature 1
0
F per hour while the compressor
is running.
- “Health Timer” – Health Timer Error
The initial pull down time has not met the health timer constraints. Refer to “Health Timer” section for
details. Press and hold key number 4 for 2 seconds will clear the error and the display will show “No Error
Codes”.
- “Health Code” – Health Code Error
The health code cooling constraints have not been met. Refer to “Health Timer” section for details. Press
and hold key number 4 for 2 seconds will clear the error and the display will show “No Error Codes”.
Press key number 1 will return to “Refrigeration” if all refrigeration summary errors have not been cleared.
To Next Page
Loading...
Need help?
General
