Operation Guide
Installing Software
Download and install the engraving
software (Falcon Design Space /
LightBurn). The machine's camera has
been automatically calibrated at the
factory, so no further calibration is
needed. If there is a significant camera
positioning deviation, it is recommended
to recalibrate. Specific files can be found
in the "Camera Calibration Guide" under
the teaching files at
wiki.creality.com/en/laser-engraver.
Creating Engraving Images
Find the image you want to
engrave. The higher the resolution,
the clearer the result.
Product Assembly
Directly refer to the product
installation steps in the manual for
product assembly, or visit
wiki.creality.com/en/laser-engraver
to view the "Assembly Guide Video"
for the product.
Setting Parameters
Set the engraving parameters. You
can refer to the "Parameter
Recommendation Table" in the file
link at wiki.creality.com/en/laser-en-
graver. For specific operations, follow
the prompts in the engraving
software or check the software
tutorial file "Software User Guide" at
wiki.creality.com/en/laser-engraver.
Start Engraving
Activate the start button and wait for
your new creation to appear.
Adjusting Focus
Place the engraving material and
use the multi-level focusing bar to
focus. Connect the computer and
device to begin our journey.
G-Code Projects
You can download the
corresponding product's
"G-code" file from
wiki.creality.com/en/laser-engrav-
er to engrave your first project
and check the structural stability
of the device.
Place the "G-code" file for the
corresponding power in the root
directory of a (self-provided) USB
drive, and use a USB-A to USB-C
adapter to connect the USB drive
to the machine's port.
Connect the (self-provided) USB
drive to the machine using the
USB-A to USB-C adapter, then press
the Start button once to adjust the
position of the engraving material.
Press the Start button
again to start the
machine and create
your project.
2
To Next Page
Loading...