0106
进料/IN
退料/OUT
暂停/STOP
6. Leveling Guide
1. Raise the platform, loosen rubber screws on the left
and right sides of the resin vat, and take out the resin vat.
2. Loose the four screws on the
connecting plate on molding platform
plate, attach calibration card on the
printing screen, press Settings →Print
Settings→ Z axis movement →Leveling,
Check whether the platform fits evenly
with the paper by referring to the steps on
Page 7.
3.After confirming that the calibration
card fit evenly, lock the four screws of the
platform.
Note: The platform has been leveled at the factory. If it needs leveling due to transportation or other reasons, please follow the steps below to
adjust the printing platform.
To Next Page
Loading...
Need help?
General
