Need help?Do you have a question about the Creality BMG CR-10 PrintHead and is the answer not in the manual?
General| Type | Print Head |
|---|---|
| Filament Diameter | 1.75mm |
| Extrusion Type | Direct Drive |
| Gear Ratio | 3:1 |
| Nozzle Size | 0.4mm |
| Drive Gear | Dual Drive |
| Compatibility | CR-10 |
| Extruder Type | BMG |
| Material Compatibility | PLA, ABS, PETG, TPU |
Verify all parts in the package are present and undamaged. Contact seller if any issues.
Mount the V6 hotend and route its wiring harness, securing cables with a zip tie.
Place the V6 hotend into the print_head_base part, ensuring the PTFE tube is inserted.
Place and twist the BMG extruder cover onto the printed parts, ensuring deep tube insertion.
Screw the back of the BMG extruder body and the motor together with M3X40 screws.
Install the M8 proximity sensor using the mounting bracket and M3x10 screws, ensuring 1mm height above nozzle.
Mount the BL-touch sensor to its bracket using provided screws and nuts. Adjust height if needed.
Connects heater cartridge, thermistor, fans, and extruder motor to specific control board ports.
Guidance on firmware upgrades, thermistor choice (104GT-2/NTC100K), and Marlin settings.
To Next Page