5. Place the V6 hotend at the installation position band and push the wire harness of the hotend into
the vertical channel. Take 1 zip tie and insert it into the print_head_base part as shown in the picture,
tighten the zip tie to fix the cables into the channel. In this step you have to decide to using which
kind of thermistor. It depends on if you want or able to flash the firmware of your board. There are
two type of thermistor in this kit. 104gt-2 is the yellow shrink tube one and the black shrink tube is
the NTC100K B3950 which commonly used by most cheap Chinese machines. If you unable to flash
the firmware of your machine you may need to install the NTC100KB3950 thermistor or if your stock
thermistor is cartridge style you can use the stock one instead. If you can flash your board to 他和
latest Marlin you can use the 104GT-2 thermistor and choose “5” Temperature sensor in the Marlin
firmware for more accurate temperature reading .
To Next Page
Loading...
