Need help?Do you have a question about the Creality CR-10 SE and is the answer not in the manual?
General| Build Volume | 300 x 300 x 400 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Bed Temperature | up to 110°C |
| Supported Filaments | PLA, ABS, PETG, TPU |
| Extruder Type | Direct Drive |
| Filament Diameter | 1.75 mm |
| Display | 4.3-inch touch screen |
| Printing Speed | up to 200 mm/s |
| Nozzle Temperature | Up to 300°C |
| Connectivity | USB |
| Power Supply | 350W |
| Leveling | Automatic Leveling |
To Next Page