Creality CR-10 SE User Manual

4.1 Power-on guide
4. About the Power-on Guide and User Interface
09
The current interface is for reference
only. Due to the continuous upgrading
of functions, it shall be subject to the
latest software/firmware UI published
on the official website.

Creality CR-10 SE Specifications

General

Build Volume	300 x 300 x 400 mm
Nozzle Diameter	0.4 mm
Bed Temperature	up to 110°C
Supported Filaments	PLA, ABS, PETG, TPU
Extruder Type	Direct Drive
Filament Diameter	1.75 mm
Display	4.3-inch touch screen
Printing Speed	up to 200 mm/s
Nozzle Temperature	Up to 300°C
Connectivity	USB
Power Supply	350W
Leveling	Automatic Leveling