Creality CR-10 SE User Manual

5. First Printing
5.3 USB flash disk Printing
18
① Insert the USB flash
disk into any USB port
② Select the model from
the USB flash disk
③ Click on “Print"
Note:
1. For details on using the software, please refer to the slicing software
user manual on the USB flash disk.
2. Saved files must be placed in the root directory (not a subdirectory) of
the USB flash disk.
3. It is recommended to use Latin alphabet, numbers, and common
characters for the file names..
4. Do not insert or remove the USB flash disk during the printing process.
④ Printing...
The current interface is for reference only. Due to the
continuous upgrading of functions, it shall be subject to
the latest software/firmware UI published on the official
website.

Creality CR-10 SE Specifications

General

Build Volume	300 x 300 x 400 mm
Nozzle Diameter	0.4 mm
Bed Temperature	up to 110°C
Supported Filaments	PLA, ABS, PETG, TPU
Extruder Type	Direct Drive
Filament Diameter	1.75 mm
Display	4.3-inch touch screen
Printing Speed	up to 200 mm/s
Nozzle Temperature	Up to 300°C
Connectivity	USB
Power Supply	350W
Leveling	Automatic Leveling