Creality CR-10 SE User Manual

5.首次打印
17
⑨ Device List⑧ Add a device: a. Add by scanning → Select a device
⑩ Equipment printing information details
⑧ Add a device: b. Add a device by manually entering the IP address
Click “Settings" →
“Network" to view
the IP address
The current interface is for reference only. Due to the continuous upgrading of functions, it shall be subject to the latest
software/firmware UI published on the official website.
5. First Printing

Creality CR-10 SE Specifications

General

Build Volume	300 x 300 x 400 mm
Nozzle Diameter	0.4 mm
Bed Temperature	up to 110°C
Supported Filaments	PLA, ABS, PETG, TPU
Extruder Type	Direct Drive
Filament Diameter	1.75 mm
Display	4.3-inch touch screen
Printing Speed	up to 200 mm/s
Nozzle Temperature	Up to 300°C
Connectivity	USB
Power Supply	350W
Leveling	Automatic Leveling