Tips: 1. Don't bend too much for daily use to prevent deformation and unusability;
2. The printing platform is a perishable part, and it is recommended to replace it regularly to ensure that the first layer of the model sticks properly.
7. Equipment Maintenance
7.1 Platform plate removal and maintenance
20
7.2 Maintenance of screw rod and guide rail
Regularly lubricate and maintain the screw rod and guide rail areas with purchased lubricating grease.
② If there are residual filaments on the
platform plate, scrape them off lightly
with a blade and print again.
③ If the first layer of the model is not
properly glued, it is recommended
to apply solid adhesive evenly on
the surface of the platform plate
before preheating for printing.
① a. When printing is finished, wait for the platform plate to cool
before removing the printing platform with the model attached;
b. Slightly bend the platform with both hands to separate the
model from the platform.
Z-axis screw rod area X-axis and Y-axis guide rail areas
X-axis guide rail area
Y-axis guide rail area
above
above
front
under
left
right
To Next Page
Loading...
