Creality CR-10 SE User Manual

3. Assembly Procedure
3.1 Light Stand Installation
① Use two M5×8 screws to align and tighten the holes on the left and right of the
light stand, and install the light stand on the gantry frame;
② Connect LED light cable;
③ Place the LED light cable into the profile groove as shown in the diagram and
secure it with sealing tape.
03
①
②
③

Creality CR-10 SE Specifications

General

Build Volume	300 x 300 x 400 mm
Nozzle Diameter	0.4 mm
Bed Temperature	up to 110°C
Supported Filaments	PLA, ABS, PETG, TPU
Extruder Type	Direct Drive
Filament Diameter	1.75 mm
Display	4.3-inch touch screen
Printing Speed	up to 200 mm/s
Nozzle Temperature	Up to 300°C
Connectivity	USB
Power Supply	350W
Leveling	Automatic Leveling