Creality BOX - User Manual

Equipment Introduction1
1. Insert the TF Card (FAT32 or exFAT formated) into the
card connector.
2. Connect the MINI/Micro USB socket of printer to the
USB1/USB2 port of the box with USB cable.
3. Connect the end of the box power cable into the box
Micro USB port, and then connect the other end to the
power adapter.
4. Turn on the power switch of the printer.
5. Open the Android phone store, google play, apple store,
etc., search for “Creality Cloud" to download the APP.
6. Open “Creality Cloud” , click “Device” →“+” . Scan the
QR on the back of the box and name it, and configure the
network according to the Creality Cloud cue phrases. When
the box is online, you can enjoy printing remotely.
1. When the yellow light goes blinking, it means the box has
started to work.
2. When the green light goes blinking, it means that the
mobile phone network configuration information has been
received, and the steady light means it is not connected to
the cloud service.
3. When the red light is always on, it means that the TF
card is not inserted.
Instructions2
11F & Room 1201, Block 3, JinChengYuan, Tongsheng Community,
Dalang, Longhua District, Shenzhen, China, 518109
Official Website: www.creality.com
Tel: +86 755-8523 4565
E-mail: info@creality.com cs@creality.com
V 1.1
CREALITY BOX
Power cable10
Yellow light: WIFI working
status
6
Green light: Cloud service or
network configuration indicator
8
Red light: TF card indicator
9
Blue light: Ethernet indicator
7
1
RJ45 port
2
Connect printer/camera
Micro USB power socket
3
TF card connector
4
Reset button
5
1
2
3
5
4
10
9 8 7 6
Ouick Start Guide
Notes: The output specification of the power adapter
is 5V 2.4A (≥ 2A); after power on, if the box doesn’t work
normally due to the wrong configurations, you can press
the reset button for over 5 seconds until the factory
settings are restored, and then configure the network again
in “Creality Cloud".

Summary

Creality Box Equipment Introduction

Printer and Camera Connection

Details how to connect a printer or camera to the device.

Micro USB Power Socket

Specifies the Micro USB port for power input.

Creality Box Setup Instructions

Install TF Card

Connect Printer

Connect the printer's USB port to the box's USB1/USB2 port.

Connect Power

Connect the box power cable to the Micro USB port and power adapter.

Power On Printer

Download Creality Cloud App

Search for and download the 'Creality Cloud' app from your app store.

Configure Network

Open the app, add device, scan QR code, and configure network settings.

Important Notes and Reset Procedure

Factory Reset

Press reset button for over 5 seconds to restore factory settings if box malfunctions.

FCC Compliance and Safety Information

FCC Part 15 Compliance

Class B Digital Device Limits

Interference Correction

FCC Radiation Exposure

Device complies with FCC radiation exposure limits; maintain 20cm distance.

Creality BOX Specifications

General

SD Card Slot	Yes
USB Port	Yes
Connectivity	USB, SD Card
Supported Materials	PLA, ABS, TPU
Function	3D Printing