Firmware:
There are few solutions for firmware problems
1. Upgrade your CR-10S machines using the firmware provide by bondtech for their DDS upgrade kit. If you choose
this firmware you have to install the 104gt-2 thermistor to the V6 hotend in our DDE kit (yellow shrink tube).
Download from here https://github.com/BondtechAB/Bondtech-CR10s/tree/master/Firmware
2. If you unable to upgrade the firmware just install the NTC100K B3950 thermistor (default thermistor on most
cheap Chinese printers) (black shrink tube one in the kit) and change the E-step to 415, try to adjust the Z-height
and manual leveling the bed，tuning the hotend PID if it is possible then you will ready to print.
3. Custom-made your own firmware. There are plenty of instruction on internet that how to upgrade the firmware
to marlin1.1.9 /2.0 of your CR or Ender series printers for better performance or thermal runaway protection or
add ABL feature ETC.
Firmware settings:
104GT-2 thermistor in marlin choose 5
NTC100K B3950 thermistor in marlin choose 1
E-steps pre MM 415
M8 proximity sensor Z-probe offset X30.2 Y0
M12 proximity sensor Z-probe offset X33.7 Y0
M18 proximity sensor Z-probe offset X37.4 Y0
BL-touch sensor Z-probe offset X38.2 Y0
Slicer settings:
Retraction length 0.8-1.2MM
Retraction speed 30-50MM
To Previous Page
Loading...
