CreatBot DS - Page 14

3).Takeoutthenutsandscrewdriverfromthe
toolboxtofixtheplatformandplatformholder
firmly.
Note:Afterinstallingtheplatforminstallation,
pleasetightenthefourblackscrewsalittlebit
moreunderthebuildplatetolowerittoavoid
knockingtheextrudersinnextoperation.
4).Connectthepowerwireanddatacableof
platformwiththeconnectors.
Caution:Makesuretheplugsarefullyconnected.
Otherwisetheplatformmaynotheatormayover
heat.
