1.4‐PreheatPLA:
PreheatPLA1:PreheatextruderandbuildplatetotheworkingtemperatureofPLArequired(Default:
Extruder,215,Buildplate,45）
PreheatPLA2:Preheatextruder2andBuildplatetotheworkingtemperatureofPLArequired(Default:
Extruder,215；Buildplate,45）
PreheatPLAAll:PreheattwoextrudersbothandbuildplatetotheworkingtemperatureofPLArequired(
Default:Extruder,215；Buildplate,45）
PreheatPLABed:PreheatbuildplatetotheworkingtemperatureofPLArequired(Default:Buildplate,45
）
1.5‐PreheatABS:
PreheatABS1:PreheatextruderandbuildplatetotheworkingtemperatureofABSrequired(Default:
Extruder,255；buildplate,45）
PreheatABS2:Preheatextruder2andbuildplatetotheworkingtemperatureofABSrequired(Default:
Extruder,255；Buildplate,45）
PreheatABSAll:PreheattwoextrudersbothandbuildplatetotheworkingtemperatureofABSrequired(
Default:Extruder,255；Buildplate,45）
PreheatABSBed:PreheatbuildplatetotheworkingtemperatureofABSrequired(Default:Buildplate,45
).
1.6‐LevelingBed:Buildplatecalibrationassist‐function.Rotatethebutton,theextruderwillmovetonext
positioninclockwisedirectionintopview.
1.7‐Cooldown:Cooldowntheextruderandbuildplatetonormaltemperature.
2‐Control:Adjustprintersettings
2.1‐Temperature:
Nozzle:Lefttemperaturesetup
Nozzle2:Righttemperaturesetup
Bed:buildplatesetup
Fanspeed:Coolingfanspeedsetup
AutoTemp:Alltheabovedatasetupautomatically
2.2‐Motion:PleasedoNOTchangeanydatainthismenuifwithoutspecialistexperience.
Accel:Acceleratedspeedofextrudermotion
Vmaxx:MaxspeedinXdirection
Vmaxy:MaxspeedinYdirection
Vmaxz:MaxspeedinZdirection
Vmaxe:Maxspeedoffeedingmotor
Vmin:Minprintingspeed
VTravmin:Mintravelspeed
Amaxx:MaxacceleratedspeedinXdirection
Amaxy:MaxacceleratedspeedinYdirection
Amaxz:MaxacceleratedspeedinZdirection
Amaxe:Maxacceleratedspeedoffeedingmotor
A‐retract:Acceleratedspeedofretract
Xsteps/mm:TransmissionratioofXmotor
Ysteps/mm:TransmissionratioofYmotor
Zsteps/mm:TransmissionratioofZmotor
To Next Page
Loading...
