CreatBot DS - Page 23

Esteps/mm:Transmissionratiooffeedingmotor
2.3‐RestoreFailsafe:PleasedoNOTchangeanydatasettinghereinthismenu.
2.4‐Savememory:Recordthecoordinateofprintingstop
2.5‐Restorefactory:Restorethemanufacturerdefaultsettings
2.6‐Firmwareversion:Currentfirmwareversion
MenusinPrintingProcess
Duringtheprinting,youcanpresstheknobtochangesomeprintingsettings.
1.Tune:Re‐setsomeparameters
‐F/R:theactualprintingspeedtakesthepercentageofthepre‐setspeedinthesoftware.Itcanbe
adjustedwhileprintingaccordingtotheactualsituation.
‐Nozzle:Temperaturesetupofleftnozzle
‐Nozzle2:Temperaturesetupofrightnozzle
‐Bed:Temperaturesetupofbuildplate
‐Fanspeed:Fanspeedsetup
‐Flow:Filamentfeedingflowrate
‐Flow0:Filamentfeedingflowrateofleftnozzle
‐Flow1:Filamentfeedingflowrateofrightnozzle
‐AutoTemp:Setalltheabovetemperatureautomatically
‐Changefilament:Tostoptheprintingandchangethefilament.Itwillrecordtheprintingstoppositionso
astocontinuetoprintafterfilamentchanging.
2.Control:PleasedoNOTchangeanydatainthismenuifwithoutspecialistexperience.
3.Pause:Tostoptheprinting,butitwillrecordtheprintingstoppositiontocontinuetheprinting.
4.StopPrint:Tofinishtheprintingjob



