CreatBot DS - Page 32

ExpertSetting
Nozzle
Nozzlesize:Nozzlediameter
CreatBot’sdefaultnozzlediameteris0.4mm.Sointhesoftwarethenozzlesize’sdefaultis0.4.Ifyouchoose
0.3mm,0.5mmor0.8mmdiameternozzle,pleasefillthecorrespondingrightfeature.
NozzlesizehasalittleinfluenceofaccuracyonZaxisdirection.Butifprintingfinestructuremodel,smaller
diametercanhelptogetbetterresult.
Therelationshipofsizeofthenozzleandprintspeedaresquaretimes,soincreasingthenozzlewillgreatly
improveprintspeed.
Filament
FilamentDiameter:Printfilamentdiameter.Pleaseusetheexactfeatureasexactlyaspossible,toobigortoo
smallwillinfluencetheextrusion.