CreatBot DS - Page 33

FilamentDiameter2:The2ndextruderfilamentdiameter.Ifthesameasthemainextruder,pleasesetas0.
Retraction
Minimumtravel:Minimumamountoftravelneededforaretractiontohappenatall.Tomakesureyoudo
notgetalotofretractioninasmallarea.Recommended2asbestperformance,toosmallwillleadto
frequentretraction.
Enablecombing:Combingistheactofavoidingholesintheprintfromtheheadtotravelover.Enable
combingextruderwillalwaystouchthesurfaceofmodelbutdisableretraction.Ifcombingisdisabledthe
printerheadmovesstraightfromthestartpointtotheendpointanditwillalwaysretract.Defaultenable
coming,butitwillincreaseprintingtime.
Minimalextrusionbeforeretracting:Theminimalextrusionthatneedstobedonebeforeretractingagain.If
aretractionneedstohappenbeforethisminimalisreachedtheretractionisignored.Thisavoidsretractiona
lotonthesamepieceoffilamentwhichflattensthefilamentandcausesgrindingissues.Recommended0.02
atbestperformance,0meansunlimitedretractionfrequency.
DualExtrusion
Dualextrusionswitchamount:Amountofretractionwhenswitchingnozzlewithdual‐extrusion.After
switching,thefilamentinthenoworkingnozzleneedtoberetractedwithsomeamounttoavoidoozing.Set
as0fornoretractionatall.Recommendedsettingas25forbestperformance.
Cool
Enablecoolingfan:Enablecoolingfanduringprintingtohelpcoolfilamentdown.
Minimallayertime:Theminimaltimeofprintinglayertoensureenoughcoolingtimebeforeprintingnext
layer.Printspeedwilladjustautomatictosatisfythisfeature.
Fanfullonatheight:Theheightatwhichthefanisturnedoncompletely.Forthelayersbelowthisthefan
speedisscaledlinearwiththefanoffat
layer0.
Fanspeedmin:Minimalfanspeedwhennormalprinting.
Fanspeedmax:Maximalfanspeedwhenautomaticslowingdownprinting.
Minimumspeed:Minimumprintingspeedofeachlayer.Recommendedsettingas10withbestperformance.
Tooslowwillresultinnozzleoozing.
Coolheadlift:Liftthehead,if
theminimallayertimeisnotenough,toextendthe coolingtimeformodel
cooling.
Spiralize
Spiralizetheoutercontour:SpiralizeissmoothingouttheZmoveoftheouteredge.Thiswillcreateasteady
Zincreaseoverthewholeprint.Thisfeatureturnsasolidobjectintoasinglewalledprintwithasolid
bottom.
Whenenablingthisfeature,thetopwillnotbeprintedandautomaticallysettinginfillas0.