CreatBot DS - Page 39

7Whenappearsomebigbubbles,justuse
needle(21)stickintothem.Thensmooththem
withyellowboard.
8Afterstickingthetapeontheplate,please
uncovertheothersideofthetape.
Note:Afterseveralprinting,thestickinessisnot
strongenough,pleasechangethetape.




LevellingBuildPlate
Notice:
•Tighteningtheblackscrew(turningthemtotheright)toreduceplateheight.
•Looseningtheblackscrew(turningthemtotheleft)toincreaseplatformheight.
•Thegapbetweenthenozzleandthebuildplateshouldbeabout75%ofthelayerthicknessyousetinthe
software.
WhyLevellingBuildPlateisImportant?
FrequentbuildplatelevellingcankeepCreatBot3DPrinterbestperformance.Re‐levellingcannothurtthe
printerbutwithoutlevellingwilldecreaseyoursuccessrateofprinting.
•Ifthebuildplateistoofarfromtheextrudernozzle,orifonepartofthebuildplateisfartherfromthe
nozzlethananotherpart,yourobjectmightnotsticktothebuildplate.
•Ifthebuildplateistooclosetotheextrudernozzle,thebuildplatewillblocktheextrudingoffilamentfrom
thenozzle.Thenozzlewillscratchthebuildplate.
•Frequentbuildplatelevellingwillhelptoensurethatobjectsalwaysstickwelltothehotbed.
PlateLevellingGuide
1Tighteningthefourblackscrewsastightasitcantoreducethebuild
plateheighttoavoidcollisionbetweennozzleandplate.