CreatBot DS - Page 41

FeedtheFilament
1Preheatthenozzle:
Choose”Prepare”>”preheatPLA(orABS)”onLCD.Choosethenozzle
youwanttopreheat.
2Feedtheendofthespooledfilamentintothefilamentguidetube,
whereitattachestotheextruder.
3Continuetofeedthefilamentinuntilitemergesfromthenozzle.
Note:PleaseDOpushthefilamentGENTLY
Iffilamentattachesthenozzle,justkeepthemattached,stoppushing
hardly.Otherwise,thenozzleconnectioncouldbebroken.
Afterthenozzleispreheatedenough,thefilamentwillflowoutfrom
nozzlenaturally.

4Tightentheblackscrewtofixthefilamentwiththeclamp,nottoo
looseortootight.
Caution:
1.Ensuretheclampisnottootightortooloose,otherwise,filamentfeedingwillhaveproblemcausing
failureprints.

2.Afterfeedingsuccessfully,checkiffilamenthastwiningandknottingtoensurefilamentfeedingsmoothly.

3.LubricatetheXYaxisandslidingblockstoavoidmotionstuck.




