CreatBot DS - Page 42

PrintfromSDCard
1Inputthe3Dmodellingfilesinourslicingsoftwareandoutputthe
GcodefilesintheSDcard.
Note:Itisbettertousethedefaultsettingsforthefirstrun.
2InserttheSDcardintoPrinter.
3Choose“PrintfromSDcard”,selecttherightGcode.
4Whenyour3Dprintfinished,thebuildplatewillmovedownandbe
heatedto50automaticallysoastotakeoutthemodelmoreeasily.
Useashoveltotakeitoutgentlytoavoidthedamageofthemodel.
Note:Ifthemodelisdifficulttoberemoved,youcanraisethebuildplatetemperatureto60.
Warning:Donottouchthenozzleuntilitiscooleddowntotally(ThetemperatureonLCDmustbelowerthan
30degrees)



