CreatBot DS - Page 52

Q:Modelsurfaceisunsmooth

A:Reducetheretractiontravel;Orreduceminimalextrusionbeforeretracting;
Note:Pleasereducetheretractionamountifretractingfrequently.
Q:Modeliseasytofalloff
A:HavingnotusedtheKaptontapeortheKaptontapelosesstickiness;Orthemodelbottomistoosmall,
youcanuseahotmeltingglueguntohelp;Addingsupportstructuretosupportmodel;Usingthefeaturein
SoftwareofAdvance‐Quality‐Cutoffobjectbottom.
Q:Thereisthejointdislocationbetweenthepartswhiledualcolourprinting.
A:Q:Thereisthejointdislocationbetweenthepartswhiledualcolourprinting.
Q:Hardtoremovethesupportstructure
A:TurnthedirectionofmodelproperlyinSoftware;Thesupportdensityshouldnotbesettoohigh;Divide
themodelintodifferentpartstoprintifnecessary.
Q:Failedprototypingofsmallmodel
A:Ifprintingasmallmodel,theextruderwillalwaysmoveinasmallspace,sotheheatwillbeconcentrated
inthemodel,andhardtobedistributed.
That'swhyitishardtoprinttheverysmallmodel.
Thesolutionistoprint3‐4piecesofthesmallmodeltogether.Ifso,theextruderwillmoveamongdifferent
models,leavingtimeforheatdissipation.
Q:CreatBot3DPrinterstopssuddenlysometimes