User Manual for Handheld Pulse Oximeter
6
In order to prolong the lithium battery's using life, please pay
attention to the battery maintenance.
3 SpO
2
Probe Connection
Connect the SpO
2
probe to the connector labeled “SpO
2
”atthe
right side of the Oximeter. After starting up the Oximeter, insert
one finger (index finger, middle finger or ring finger with
proper nail length) into the probe according to the
demonstration shown in the following figure.
Figure 3-1 Demonstration for Using SpO
2
probe (finger clip)
Instructions of Operation
1. The finger should be put in properly and correctly.
2. Do not shake the finger and keep at ease during
measurement.
3. Do not put wet finger directly into sensor.
4. Avoid placing the sensor on t he same limb which is wrapped
with a cuff for blood pressure measurement or during
venous infusion.
To Next Page
Loading...