Using Creative PC-CAM 900 as a Digital Camera 3-3
Recording
Audio or Video
1. Be sure that your camera is not connected to your computer.
2. Turn the Mode Selector dial to Audio or Video mode .
3. For videos, compose your picture and press the Snap button to begin recording.
For audio recordings, place the camera close to the audio source and press the
Snap button.
You can see both the elapsed and remaining recording times, shown in
seconds, at the upper right corner of the LCD.
Press the Snap button again to stop recording.
Replaying a
Recording
1. Turn the Mode Selector dial to Playback mode .
2. Use the Left and Right keys on your Multi Selector button and locate your
recording on the LCD screen.
3. Press the Snap button to start playback.
To stop playback, press the Left key.
To pause playback, press the Right key To continue playback, press the Right
key again.
• A "Disk Full"
message appears
when there is
insufficient
remaining memory
in your camera.
•All videos are
recorded at 320 x
240 resolution.
To Next Page
Loading...
