INSTRUCTION
MANUAL
11
Installing your Freestanding Cooker
Bringing it all together
Installation requirements
THIS COOKER MUST BE INSTALLED BY A QUALIFIED INSTALLER IN ACCORDANCE WITH LOCAL
REGULATIONS
IMPORTANT: CONTACT AN AUTHORISED SERVICE AGENT FOR INSTALLATION OF YOUR OVEN!
First Use
IMPORTANT: When using your oven for the first time your cooker may give off an unusual odour from the heating
elements and insulation materials. This is normal for new cookers. To eliminate this odour run the oven at 250
degrees for 40-60 mins with the oven empty.
Unpacking
Carefully unpack and examine the appliance for any damage. If you think there is a defect, do not use the appliance
and contact Product Support on 01759 487836.
Positioning
Check if the electrical installation is proper to bring the appliance in operating condition. If electricity installation is not
suitable, call an electrician and plumber to arrange the utilities as necessary. Manufacturer shall not be held
responsible for damages caused by operations performed by unauthorized persons.
WARNING: It is customer’s responsibility to prepare the location the product shall be placed on and to have the
electrical installation prepared.
WARNING: The rules in local standards about electrical installations shall be followed during product installation.
WARNING: Check for any damage on the appliance before installing it. Do not have the product installed if it is
damaged. Damaged products cause a risk for your safety.
Right Place for Installation and Important Warnings
Appliance feet should not stay on soft surfaces such as carpets. The kitchen floor shall be durable to carry the unit
weight and any other kitchenware that may be used on the oven.
The appliance is suitable for use on both side walls, without any support, or without being installed in a cabinet. If a
hood or aspirator will be installed above the cooker, follow the instructions of the manufacturer for height of
mounting. (min. 650 mm)
To Next Page
Loading...
