Creda C90RCCCBL - Page 26

INSTRUCTION
MANUAL
26
TECHNICAL FEATURES AND PRODUCT
SUPPORT.
WARNING: For the modification to be done by authorized service, this table should be considered. Manufacturer
may not be held responsible for any problems rising because of any faulty modification.
WARNING: To increase the product quality, the technical specifications may be changed without prior notice.
WARNING: The values provided with the appliance, or its accompanying documents are laboratory readings in
accordance with the respective standards. These values may differ depending on the use and ambient conditions.
Rack Positions
It is important to place the wire grill into the oven properly. Do not allow wire
rack to touch rear wall of the oven. Rack positions are shown in the next
figure. You may place a deep tray or a standard tray in the lower and upper
wire racks.
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure, first remove the lower, and then the upper side from
installation location. To install wire racks; reverse the procedure for removing wire rack.
Outer width
900 mm
Outer depth
600 mm
outer height
900 mm
Lamp power
15 - 25 W
Grill Oven
Main
Oven RHS
Bottom heating element
Top heating element
Turbo heating element
1800 W
Grill heating element
1400 W
Supply voltage
220-240 V AC 50/60 Hz
Total electrical consumption
Type Code
MFR0/9052103E
13210 W
1800 W