Crem EX Series - Display PID: Service Coffee Counter; Display PID: Total Counters Check; Display PID: Clock Setting Configuration; Display PID: Auto On;Off Setting

29
Original instructions.
· Scc – Service coee counter
To consult the Service coee counter, follow the steps below:
1. When [Scc] is shown on the display, enter by pressing K5.
2. The counter will be shown in the 3 digits display by changing between thousands (with a dot) and units in the
following format: [000. - 000]. Eg. 12500 coees: [012. - 500].
i
Note:
Service coee counter setting is adjusted on the Service menu. It is disabled by default, so the partial
counter will show 0 by default.
Alarm [SEr] will be shown on the display when the partial counter reaches the set value to inform
that the periodic maintenance must be executed. To reset the partial Service coee counter, consult
‘Messages & Alarms’ section of this manual.
· cLo – Clock setting
· tot – Total counters
To consult the Total counters, follow the steps below:
1. When [tot] is shown on the display, enter by pressing K5.
2. The counters will be shown in the 3 digits display by changing between thousands (with a dot) and units in
the following format: [000. - 000].
3. Browse through the counter by pressing K5. Them will follow this order:
[tot] Total coee counter -> K5 -> [000. - 000] -> K5 -> [Gr1]
[Gr1] Group 1 coee counter -> K5 -> [000. - 000] -> K5 -> [Gr2]
[Gr2] Group 2 coee counter -> K5 -> [000. - 000] -> K5 -> [Gr3]
[Gr3] Group 3 coee counter -> K5 ->[000. - 000] -> K5 -> [tEA]
[tEA] Automatic tea counter -> K5 -> [000. - 000] -> K5 -> [Lit]
[Lit] Total liter counter [000. - 000] -> K5 -> [tot]
USER PROGRAMMING - DISPLAY PID VERSIONS
· AUt – Auto On/O setting
To change the Auto On/O setting, follow the steps below:
1. When [AUt] is shown on the display, enter by pressing K5.
2. Select with K1 and K2 the Auto On/O settings.
3. Browse and set the auto on/o following this format:
On time [on] -> K5 -> On Hour [00h] -> K5 -> On Minutes [00M] -> K5 ->
O time [oFF] -> K5 -> O Hour [00h] -> K5 -> O Minutes [00M] -> K5 ->
Day o [dFF] -> K5 -> Day O [oFF] / [0Xd]* -> K5
*[oFF] No day o [01d] Monday [02d] Tuesday; ... ; [07d] Sunday
To change the Clock setting, follow the steps below:
1. When [cLo] is shown on the display, enter by pressing K5.
2. Select with K1 and K2 the clock settings.
3. Browse and set the clock following this format:
Hour [00h] -> K5 -> Minutes [00M] -> Week day [00X].
Weekdays: [001] Monday; [002] Tuesday; … ; [007] Sunday
i
Note:
All selections add +1 to the counters.
Every brewing shot below 5 seconds won’t be accounted
i
Note:
Auto On/O setting is disabled by default on the Service menu.