9
English
Starting up
– Never place the machine nearer than 60 cm to the sink. The power ca-
ble and plug should never be allowed to get wet (risk of electric shock)
– If you need an extension cable, make sure it is suitable for your machine
(3-pole grounded, and at least
1.0 mm²
conductor cross-section), and
lay the cable to avoid tripping
− Remove the protective foil from the perforated drip tray grates and
insert them in the drip trays
Important:
– Danger of electric shock! Never clamp or run the power cable over
sharp corners or edges or hot or wet surfaces
– Pull out the power plug before moving or cleaning/servicing the ma-
chine, or if it won’t be used for a long time (e.g. during holidays)
– To make sure that the machine is switched off, remove the plug from
the power point
2. Filling / Refilling the water tank
The cleaning key goes blue if the water tank is empty.
There are two ways to fill the water tank: directly into the machine, by
using for example a jug, or by removing the water tank.
Filling without removing the tank
– Remove the water tank lid
– Fill the tank up to the «MAX» mark with cold water (the maximum
capacity is 1 litre)
– Replace the lid
Filling by removing the water tank
– Remove the water tank lid
– Lift up the water tank holding it by the special grip (on the outside of the
water tank) and remove it from the machine
– Fill the tank up to the «MAX» mark with cold water (the maximum
capacity is 1 litre)
– Lower the water tank into place, pushing firmly
– Replace the lid
Continued...
Cremesso-Compact-Automatic 262-ENGLISH-FOR ISRAEL--DH-15a-FINAL.indd 9 15.08.11 KW 33 13:12
To Next Page
Loading...
