37
EN
P90-20191122A
CHANGING COLORED PROTECTED COVER
The DIGI 2 console is covered by a silicone shell that gives the
product its special look while also protecting it from accidental blows.
Users or an authorized center can replace the shell by following these
steps:
• Disconnect the device from the first stage/regulator group.
• Separate the shell from the body of the instrument, beginning
with the point shown.
• Pull gently outward, undocking the cover from the four perimeter
anchor points.
• At this point, slide the cover to be replaced over the hose.
• Slide on the new cover, taking care to insert all the stops in their
respective grooves.
• Reconnect the instrument as explained in chapter:
“HOW TO CONNECT THE DIGI 2 CONSOLE”.
To Next Page
Loading...
